Wet Drum Magnetic Separator For CPP CR9/21-P2L - OB

Pulp Volume Capacity:	294 m³/h nominal. 336 m³/h maximum.
Magnetite Solids Capacity:	Up to 59 t/h at 200g/L recommended or 74 t/h at 250 g/L maximum.
*Magnetite recovery efficiency:**	99.9 %.
*Magnetite recovered at:**	2.3 R.D.
Magnet Assembly:	Radial field type with Ferrite magnets sandwiched between steel poles. Effective Angle = 136 ° Ferrite magnets Y30BH type. bHc ~ 2800 Oersteds. Br ~ 3800 Gauss.
Magnetising Field:	Gauss ~2000 ~1500 ~1000 ~ 550	Gauss ²/cm ~1020 000 ~650 000 ~290 000 ~ 75 000	Drum 10 mm 25 mm 50 mm

Gauss measurements are the vertical fields measured at the poles, with axial type probe.

Tank Style:	Counter-rotation.
Special Features:	Tank with overflow compartment for clarified water. Flanged pipe outlet at bottom of compartment. Clarified water amount set by full width adjustable weir plate.
Drum Drive:	Helical bevel gearbox with flange mounted electric motor. Manufacturer : SEW-Eurodrive Arrangement: Shaft mount FA97 2.2 kw. Drum speed: 8 r/m. Motor mechanical protection: IP65.
Drum Bearings:	Spherical Roller type, designation 22220 cck. Re-lubrication – not required on drive side (shielded type); through grease nipple at end of shaft on non-drive end.
Drum Drive shaft support bearing:	Plumber block type, designation SNH520. Re-lubrication through grease nipple on housing.
Trash Screen:	Installed in feed box.
Cleaning:	200mm bung at either end of tub and feedbox and flush with the bottom.
Pulp Level Setting:	By orifice plates at tank outlets.
Drum Adjustment:	Horizontal and vertical – with jacking bolts – adjustment can be made in operation. Factory settings:- Drum – Tank gap 50 mm. Drum – Mags. discharge gap 40 mm.
Magnet Assembly adjustment:	Angular – with spanner fixed to non-drive end of magnet support shaft. Position set at factory.
Construction Materials:
Feedbox and Tank:	3 & 4,5 mm Stainless steel (304)
Drum Shell:	3 mm Stainless steel (304)
Wear Wrap:	3 mm Stainless steel (304)
Drum Ends:	12 mm Stainless steel (304)
Trash Screen:	Stainless steel 304 wire 3mm Ø x 10 mm aperture.
Support Frame:	Carbon steel (ms), sections and plate.
Magnet Assembly support shaft:	Carbon steel (En3a).
Bearing Enclosure:	Carbon steel (ms).
*Corrosion Protection:*
Carbon Steel Parts:	Sandblast and three coat epoxy paint System D.F.T. 105 microns; or galvanised.
Stainless Steel parts:	Acid cleaned polished.
Proprietary Items:	Manufacturers standard finish.
*	With magnetite size distribution, typically:- 95 % < 53 microns 90 % < 45 microns 30 % < 10 microns